Cb antenna booster free#

This will help us determine the system that is needed to improve cell coverage. Upon receipt of questionnaire, we will perform residential or business site survey. If outside signal is too weak (weaker than -110 dB), submit request for cell coverage solution assessment. bracket, the more powerful the signal amplifier with greater Gain as well as higher uplink and downlink output power. If outside signal is very weak, we suggest choosing the kit with even more higher sq. For best results: If outside signal is weak, we suggest choosing the next higher sq. coverage is based on good signal outside. Website is easy to use with plain straight forward info but could have had more on testing signal strength to make sure you get a strong enough booster. of Anderson, California gave the following review: area will be considerably lower, accordingly. Square footage stated in signal booster listings is based on good signal outside.

Before ordering, please check outside signal level in decibels or ensure that you can make and hold a phone call at any good spot outside where you can mount an exterior antenna. Note: For any signal booster to help, outside signal strength must be at least -110 dB or there must be a clear line of sight to a cell tower that is within twenty miles. Chemicals in these materials might destroy or damage the finish. WARNING: Do not let paint solvents, cleaning solvents, or adhesive caulking come in contact with antenna.

To clean antenna, use mild dishwashing liquid (one that is not harsh to the hands and without ammonia) in lukewarm water. This antenna works equally well on fiberglass, wood, or metal boats. Included cable can be lengthened using suitable connectors and 50-ohm RG-58 or RG-8 coax (each sold separately), without detrimental effect to antenna performance. Drill a 3/4 inch hole for passage of the cable and connector, and seal the hole with the included rubber grommet.Īny excess cable should be rolled in a coil of at least 8 inch diameter and stowed in an out-of-the-way place, away from other electrical cabling.

Route the cable to your CB radio, keeping it as far as possible from other electrical equipment and cables.Follow the instructions included with the mount you choose. Mount the antenna using a Deck Mount (sold separately) or similar mount. IMPORTANT: DO NOT CUT THE CABLE OR REMOVE THE CONNECTOR.

Cb antenna booster free#

Note: Antenna will read shorted on continuity test - disregard.Ĭhoose a mounting location that is as high as possible, as free as possible from obstructions, and as far as possible from other antennas and strong sources of RF, but within reach of the antenna's coax cable.

Tools required (not included): Drill and 3/4' drill bit.

Suggested mount (not included): Nylon Marine Ratchet Mount.

The cable cannot be cut, but can be lengthened using an extension coax with suitable connectors (each sold separately).

Marine CB Antenna Assembly 4051 with Rubber Grommet.This 3' (0.9 m) antenna comes with a 1'-14 thread nylon ferrule. This is a one-piece, continuous-load, end-fed 1/2-wave CB Marine antenna with supplied cable. Marine antenna mount suggested (not included). Coil is permanently sealed in white fiberglass. antenna is more desirable for greater range. It is great for bass boats and other boats where fishing with 3 ft. RG58 cable.ģ feet tall CB Antenna is Unity Gain Marine Antenna. Marine CB Antenna with nylon ferrule and 7 ft.